Introduction
We built this heater for the machines that need serious, concentrated heat—but absolutely refuse to put up with the usual noise and rattle. It’s a quartz-tube, shortwave infrared heater. The whole idea was to give you stable, powerful heat in tight spots, where keeping things quiet and under control really matters.
What it’s really about
This thing runs at 400V and 2500W, so you get a lot of punch in a small package. The 300mm tube focuses the heat into one specific area, which means you can target exactly what you need to heat—without having to over-engineer the whole machine. And because it’s high voltage, the current draw is lower. That lets you use smaller conductors and keeps the wiring path cleaner. Less clutter. Less guesswork.
The build that matters
The quartz tube is halogen-filled, which helps keep the filament stable and stretches the lifespan compared to bare-wire designs. There’s also a reflective coating on the tube that pushes the energy forward—so more heat lands where you want it, and less is wasted. And the R7s connector? It’s a simple, straight two-pin setup. You wire it in fast, and it drops right into existing fixtures with no drama.
Where it shines
Use this when you need heat that responds quickly and hits hard—think plastic heating, coating curing, and packaging sealing. Because it’s built to be low-noise, you get less vibration and less acoustic interference. That helps your process stay consistent, day after day. Just keep one thing in mind: 2500W at 400V delivers a lot of heat density. Make sure your machine’s cooling and airflow are up to the job, so nearby components don’t get pushed past their limits.